Multi-Kill Pest Control Reusable Rat Rodent Zapper Electronic Mouse Trap Killer

Beskrivning

Special features:
1. The electric mouse trap uses a high-voltage shock to instantly kill mouse as long as it gets into the trap, but purely no pain to them, no chance of letting it get away
2. When you turn on the switch, you will see the indicator light and hear the beep sound, it means the trap is ready to catch mouse
3. The trap can be operated with four batteries or AC adapter(USA plug or EU plug), you can choose one that fits you most
4. Stor kapacitet: The electronic rodent zapper can catch 10 mice, the larger capacity design is more convenient to use
5. Two entrances on the both side of the trap increase more catching chance
6. No blood and no need to touch the rodent. Just take out the storage box, it is just like a drawer, and throw the dead body into the trash can, then clean it with water
7. Special humane escape route design: If some mice are not killed by the electric shock and still alive, they may bite the trap and even bite each other, so for this reason, we make a hole on the storage box and inside the trap, there is also an escape door beside the entrance

Attention:
1. Please use the side with storage box to face the wall when using the trap
2. Please always check that the trap is in armed mode when placing it
3. Regularly check the trap is in armed mode when in use
4. Empty and clean the trap, and change batteries when needed
5. Indoor use only! Not for barns, stables and similar
6. Not for locations with moist, condensation, nor flammable vapour or dust
7. Not to be used by persons with reduced capabilities
8. Not to be used by or accessed by children, nor the pets
9. The bait can only be put in the bait box, and outside the trap entrance(stairs)
10. Do not use an excessive amount of bait, avoid any bait on the electrode plates and preferable use a bait of sticky texture
11. Turn off the trap and disconnect it from the power supply before handling it. E.g when moving or clean the trap
12. Using gloves when operating the trap,i.e when disposing the dead body. Wearing gloves is a hygienic measure, as well as it ensures that human scent is not left on the trap which may otherwise deter mice
13. If the trap is not in use for a long time: Remove the batteries and disconnect the power cord

Operation steps:

1. Start: Detach the base of the trap by sliding the top part toward the side where the “on/off” switch is located. Lift the top straight up when unlocked, do the opposite steps to attach the top and bottom of the trap. Make sure the parts are locked in position and fully aligned

2. Driva: Insert 4x C(LR14) batteries or connect the power cord

3. Bait: Slide out the bait box and put a small amount of sticky bait

4. Position: Place the trap alongside a wall on a flat surface, in a dry and well-ventilated place(Please note that use the side with storage box to face the wall)

5. Activate: Set the switch to ON. The indicator light will show if the trap starts successfully and is in armed mode(See indicator light)

6. Catch: The trap releases a series of high voltage shocks instantly killing the mouse. Thereafter the floor slides open, releasing the mouse into the storage box

7. Clean: When the storage box is full(up to 10 mice), empty the storage box and dispose it. Clean the trap after each time it has been emptied. Always turn the trap OFF before cleaning

Indicator light signals:

1. Power on: Solid green light and sound signal 2 “beep” after successful start sequence the trap will enter armed mode

2. Armed: Red light blinks every two seconds

3. Kill: Solid red light followed by sound signal 2 “beep”

4. Battery low: Green light every two seconds

5. Problem/full: Sound signal 4 “beep” followed by alternating red and green lights