Описание
433/315MHz RF Remote Control Switch Motor Controller KL-K201C
Operation Method:
1. Match code:
Hold learning button and learning indicator light blinks, then press any buttons of remote control, if indicator flashes 3 раз, matching is done. Maximum 20 remote controls can be matched.
2. Delete code:
Hold learning button till the indicator LED lights and then off, delete successfully.
3. Set working mode:
С1 & S2 program the sequence as follows:
Jumper on S1→ Toggle
Jumper on S2→ Latching
No Jumper on S1 &S2→ Momentary
Tech Data:
| Вход | DC 12V (DC9V, 24V can be customized) |
| Channels | 2 |
| Working Current | 8mA |
| Working Frequency | 433МГц / 315МГц, Необязательный |
| Receiving Sensitivity | -103dBm |
| Decoding Type | Leaning Code(EV1527) / Fixed Code(PT2262) |
| Working Mode | Momentary / Toggle / Latching |
| Output Mode | Switching Signal (Dry Contact) |
| Max Load | 5А (Relay Contact) |
| Измерение | 58*40*15мм |
Working Mode:
1. Momentary: Press remote button A, the corresponding relay on the receiver is on; release button A, the relay is off, the same as others.
2. Toggle: Press remote button A, the corresponding relay on the receiver is on; press button A again, the relay is off, the same as others.
3. Latching: Press remote button A, the relay A is on, B is off; press button B, the relay B is on, A is off.
Wiring Way & Diagram:
B=Normally Closed, K=Normally Open, G=Common.
Please refer to below picture as wiring diagram:
Перевозки
1) Express: ДХЛ, FedEx, UPS, ТНТ, EMS, так далее.
2) By air
3) By sea
4) By special line
Depends on buyer’s requirement.
Our website:
http://szklvn.en.made-in-china.com/